A network's physical topology refers to the arrangement of the cabling and how the devices connect to each other.
True or False
question
True
answer
A point-to-point topology is typically used for WAN connections or wireless bridges.
True or False
question
True
answer
A network's logical topology often depends on the central device's electronics.
True or False
question
False
answer
A collision can occur on a switch only if the switch is operating in full-duplex mode.
True or False
question
signal bounce
answer
In a physical bus topology, both ends of the medium must be terminated in order to prevent what?
signal propagation
signal bounce
signal degradation
collision
question
single point of failure
answer
Which of the following is NOT an advantage of a physical star?
easier network upgrades
centralized monitoring and management of traffic
use of faster technologies
single point of failure
question
physical ring
answer
Which of the following is the physical topology that is daisy-chained like a bus and in which the cabling is brought around from the last device to the first device?
physical bus
physical star
physical ring
point-to-point
question
data travels on a dedicated link
answer
What is an advantage of a point-to-point topology?
data travels on a dedicated link
provides redundancy and fault tolerance
relatively inexpensive
a reliable and fast backbone
question
logical bus
answer
What type of logical topology is at work when using an Ethernet hub?
logical bus
logical ring
switched topology
hierarchical topology
question
Point-to-multipoint
answer
In which topology does a central device communicate with two or more other devices and is used in WANs where a main office has connections to several branch offices via a router?
logical bus
logical star
switched
Point-to-multipoint
question
switched / Ethernet
answer
What is the most common topology and technology combination in use today?
logical bus / Ethernet
logical bus / wireless LAN
logical ring / token ring
switched / Ethernet
question
maximum speed is 100 Mbps
answer
Which of the following is NOT a characteristic of Unshielded Twisted Pair cabling?
contains four pairs of copper wire
susceptible to electrical interference
maximum speed is 100 Mbps
comes in numbered categories
question
cyclic redundancy check
answer
What is in an Ethernet frame's trailer?
source MAC address
destination MAC address
frame payload
cyclic redundancy check
question
CSMA/CD
answer
What is the media access method used by Ethernet?
CSMA/CD
Token passing
CSMA/CA
Polling
question
They can occur on Ethernet half-duplex networks
answer
Which of the following is true about collisions?
They can only happen with switches
They are a problem with Token Ring networks
They can occur on Ethernet half-duplex networks
Fewere computers means more collisions
question
the transmission speed, the type of transmissions, and the length or type of cabling
answer
When discussing Ethernet standards, what does the XBaseY terminology refer to?
the length or type of cabling, the transmission speed, and the type of transmissions
the transmission speed, the type of transmissions, and the length or type of cabling
the transmission speed, the length or type of cabling, and the type of transmissions
the length or type of cabling, the type of transmissions, and the transmission speed
question
802.11
answer
What is the IEEE standard governing wireless networking?
802.3
802.5
802.3ab
802.11
question
ad hoc
answer
When a wireless computer uses a peer-to-peer connection to directly connect to another wireless computer, it is operating in what mode?
infrastructure
ad hoc
hot spot
Wi-Fi
question
CSMA/CA
answer
In wireless networks, what type of media access control is used?
CSMA/CD
Polling
CSMA/CA
Token passing
question
Time-to-Live
answer
Which of the following is NOT a field in an Ethernet frame?
Time-to-Live
Type
FCS
Source MAC
Haven't found what you need?
Search for quizzes and test answers now
Quizzes.studymoose.com uses cookies. By continuing you agree to our cookie policy