Networking Chapter 11

What protocol is commonly used to aggregate / bond T-1 / T-3 lines?

Which version of DOCSIS provides 38 Mbps per channel and requires a minimum of 4 channels to be used?

​What is the frequency range of the C-band that is used by satellites?

What is the maximum amount of throughput provided by an OC-12?

In metro settings, end-to-end, carrier-grade Ethernet networks can be established via what protocol?

When using frame relay, what is the name of the identifier that routers use to determine which circuit to send frames to?

What is the maximum throughput of a DS3 connection?​

The best 802.11n signal can travel approximately how far?

What xDSL standard is the most popular?​

What OC level is primarily used as a regional ISP backbone, and occasionally by very large hospitals, universities, or other major enterprises?​

The DTE or endpoint device for a leased line is known as which device below?

How many channels exist in a T1 connection?​

What Layer 3 technology is employed by distance-vector routing protocols in which a router knows which of its interfaces a routing update and will not retransmit, or advertise, that same update on the same interface?

When copper cabling is used to carry T-1 traffic, what kind of connector is used?

Which option below is an advantage of leasing a frame relay circuit over leasing a dedicated circuit?

What is the size of an ATM packet?​

In a PON system, an OLT contains a splitter that splits each port into how many logical channels?​

What xDSL version provides a maximum throughput of 24 Mbps downstream and 3.3 Mbps upstream?

In an ISDN connection, what is the size throughput did a single B channel provide?​

In what type of topology is each site connected to two other sites, ​providing redundancy?