Testout Section 2.4

21 August 2022
4.7 (114 reviews)
13 test answers

Unlock all answers in this set

Unlock answers (9)
question
You are building network cables and attaching RJ45 connectors to each end. Which tool do you need for this task?
answer
Crimping tool
question
What tool should you use to extend network services beyond the demarc?
answer
Punchdown tool
question
You are making Ethernet drop cables using Cat5e cable and RJ45 connectors. You need to remove the plastic coating over the cable to expose the individual wires. What tool should you use?
answer
Cable Stripper
question
You are working with 25 pair wires and 66 blocks. You have pushed the wires onto the 66 block, but now need to cut off the excess end of each wire. What tool do you use?
answer
Punchdown tool
question
Which of the following connector types are used with UTP cables? (Select two)
answer
-RJ45 -RJ11
question
Which of the following describes the point where the service providers responsibility ends and the customers responsibility begins for installing and maintaining wiring and equipment?
answer
Demarc
question
You have a network that occupies all three floors of a building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. You have a wiring closet on the two remaining floors directly above the wiring closet on the main floor. What would you use to connect the wiring closets together?
answer
Vertical Cross Connect
question
You have a network that occupies the top floor of a three story building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. What would you use to relocate the WAN line into a wiring closet on your floor?
answer
Demarc extension
question
You have a network that occupies all three floors of a building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. You have a second wiring closet on the main floor. You need to connect the two wiring closets. Which of the following are typically used to connect the two wiring closets? (Select two.)
answer
-Horizontal Cross connect -25 Pair
question
You have a network that occupies both floors of a building. The WAN service provider has installed the line for the WAN service into the building in a wiring closet on the main floor. You have a second wiring closet on the second floor directly above the wiring closet that holds the demarc. Which of the following terms describes the closet on the second floor?
answer
IDF
question
Which of the following is used to terminate individual wires from a 25 pair or 100 pair cable using female RJ-45 ports?
answer
Patch Panel
question
You want to use the T568B standard for adding connectors to your Cat5 cable. Starting with pin 1, which order should you use for the wires within the connector?
answer
White/orange, orange, white/green, blue, white/blue, green, white/brown, brown
question
Which of the following methods would you use to create a crossover cable?
answer
Use the T568A standard on one connector, and the T568B standard on the other connector.