Which command is used to set the BOOT environment variable that defines where to find the IOS image file on a Switch?
answer
Boot System.
question
What is a function of the switch boot loader?
answer
To Provide an environment to operate in which the switch operating system cannot be found.
question
Which interface is the default location that would contain the IP address used to manage a 24-port Ethernet Switch?
answer
VLAN 1.
question
In which situation would a technician use the show interfaces switch command?
answer
When packets are being dropped from a particular directly attached host.
question
Refer to the exhibit. What media issue might exist on the link connected to Fa0/1 based on the show interface command?
answer
There could be too much electric interference and noise on the link.
question
If one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?
answer
On the half-duplex end of the connection.
question
What is one difference between using telnet or SSH to connect to a network device for management purposes?
answer
Telnet sends a username and password in plain text, whereas SSH encrypts the username and the password.
question
Where are dynamically learned MAC Addresses stored when sticky learning is enable with the switchport port-security mac-address sticky command?
answer
RAM.
question
Refer to the exhibit. Port Fa0/2 has already been configured appropriately. The IP phone and PC work properly. Which switch configuration would be most appropriate for port Fa0/2 if the network administrator has the following goals?
No one is allowed to disconnect the IP phone or the PC and connect some other wired device.
If a different device is connected, port Fa0/2 is shut down.
The switch should automatically detect the MAC address of the IP phone and the PC and add those addresses to the running configuration.
Refer to the exhibit. What can be determined about port security from the information that is shown?
answer
The port violation mode is the default for any port that has port security enabled.
question
Match the step to each switch boot sequence description. (Not all options are used.)
answer
Step 1: Execute POST
Step 2: Load the boot loader from ROM.
Step 3: Initializes CPU register initializations.
Step 4: Flash file system initialization.
Step 5: Load the IOS.
Step 6: Transfer Switch Control to the IOS.
Haven't found what you need?
Search for quizzes and test answers now
Quizzes.studymoose.com uses cookies. By continuing you agree to our cookie policy
